Assessment of Power Harvesting in Electronic Modules Using Phase Change Material with Null Electricity: An Experimental Study

K. Gopi Kannan, R. Kamatchi

Abstract


In this work, the assessment of power harvesting in electronic modules during its operation is experimentally investigated. The phase change material (PCM) based natural cooling is analyzed with a developed model using different circulating fluids such as DI water, ethanol, and methyl acetate respectively. The experiments are conducted to evaluate the power harvesting by PCM for circulating fluids at the different heat input between 60 and 110 W. Result implies that (i) highest percentage of waste heat extraction is about 98.7% for methyl acetate because of low boiling point and heat of evaporation at high heat input (ii) thermal resistance of methyl acetate is less of about 0.237 K/W owing to high vapour flow rate and less subcooling effect (iii) the maximum power harvested by PCM with the effect of vapourized methyl acetate is found as 9.41 W owing to less time to reach the steady-state temperature (SST) of PCM at 110 W.

Keywords


Circulating fluids, waste heat; electronic modules; phase change material; power harvesting

Full Text:

PDF

References


R. Ye, R. Huang, X. Fang, and Z. Zhang, “Simulative optimization on energy saving performance of phase change panels with different phase transition temperaturesâ€, Sustain. Cities Soc, Vol. 52, pp. 101833, Jan 2020.

S. Gareh, B.C. Kok, M.H. Yee, A.A. Borhana, and S. K. Alswed, “Development of a novel compression-based piezoelectric traffic model for improving the roadways energy harvesting system by applying the celular atomata traffic modelâ€, Int. J. Renew. Energy Res, Vol. 9, No. 4, pp. 2101-2111, Dec 2019.

F. Anggara, R.A. Anugrah, and H. Pranoto, “Thermal energy storage using horizontal shell-tube heat exchanger: numerical investigation on temperature variation of HTFâ€, Int. J. Renew. Energy Res, Vol. 9, No. 4, pp. 2112-2117, Dec 2019.

P. Kumar, S. Kumar, R. Kumar, and S. Mandal, “Numerical and experimental analysis of Scheffler concentrator receiver for steam generation using phase change materialâ€, Int. J. Renew. Energy Res, Vol. 8, No. 3, pp. 1339-1345, Sep 2018.

T. Nehari, M. Benlekkam, D. Nehari, and A. Youcefi, “The effect of inclination on the passive cooling of the solar PV panel by using phase change materialâ€, Int. J. Renew. Energy Res, Vol. 6, No. 1, pp. 132-139, Mar 2016.

R. Baby, and C. Balaji, “Thermal optimization of PCM based pin fin heat sinks: an experimental studyâ€, Appl. Therm. Eng, Vol. 54, No.1, pp. 65-77, May 2013.

E.M. Alawadhi, and C. H. Amon, “PCM thermal control unit for portable electronic devices: experimental and numerical studiesâ€, IEEE Trans. Components Packag. Technol, Vol. 26, No. 1, pp. 116-125, Jun 2003.

S.K. Sahoo, M.K. Das, and P. Rath, “Application of TCE-PCM based heat sinks for cooling of electronic components: A reviewâ€, Renew. Sustain. Energy Rev, Vol. 59, pp. 550-582, Jun 2016.

K.G. Kannan, R. Kamatchi, T. Venkatajalapathi, and A.S. Krishnan, “Enhanced heat transfer by thermosyphon method in electronic devicesâ€, Inter. J. Heat Technol, Vol. 36, No.1, pp. 339-343, Mar 2018.

A. Goldoust, M.R.S. Emami, and A.A. Ranjbar, “Experimental investigation of the evaporator section tilted angle and filling ratio on the thermal characteristics of a two-phase closed thermosyphonâ€, Inter. J. Heat Technol, Vol. 37, No. 2, pp. 569-574, Jun 2019.

A. Samba, H. Louahlia-Gualous, S. Le Masson, and D. Norterhauser, “Two-phase thermosyphon loop for cooling outdoor telecommunication equipmentsâ€, Appl. Therm. Eng, Vol. 50, No. 1, pp. 1351-1360, Jan 2013.

Q. Liu, K. Fukuda, and P.F. Sutopo, “Experimental study on thermosyphon for ship board high-power electronics cooling systemâ€, Heat Transf. Eng, Vol. 35, No. 11-12, pp. 1077-1083, Jul 2014.

M. Zhang, Z. Liu, and G. Ma, “The experimental investigation on thermal performance of a flat two-phase thermosiphonâ€, Int. J. Therm. Sci, Vol. 47, No. 9, pp. 1195-1203, Sep 2008.

A. Kamyar, K.S. Ong, and R. Saidur, “Effects of nanofluids on heat transfer characteristics of a two-phase closed thermosiphonâ€, Int. J. Heat Mass Transf, Vol. 65, pp. 610-618, Oct 2013.

M. Narcy, S. Lips, and V. Sartre, “Experimental investigation of a confined flat two-phase thermosyphon for electronics coolingâ€, Exp. Therm. Fluid Sci, Vol. 96, pp. 516-529, Sep 2018.

B. Palm, and R. Khodabandeh, “Choosing working fluid for two-phase thermosyphon systems for cooling of electronicsâ€, J. Electron. Packag, Vol. 125, No. 2, pp. 276-281, Jun 2003.

J. Li, W. Tian, and L. Lv, “A thermosyphon heat pipe cooler for high power LEDs coolingâ€, Heat Mass Transf, Vol. 52, No. 8, pp. 1541-1548, Aug 2016.

J. Krishna, P.S. Kishore, and A.B. Solomon, “Heat pipe with nano enhanced-PCM for electronic cooling applicationâ€, Exp. Therm. Fluid Sci, Vol. 81, pp. 84-92, Feb 2017.

M.T. Chaichan, and H.A Kazem, “Using aluminium powder with PCM (paraffin wax) to enhance single slope solar water distillation productivity in Baghdad–Iraq winter weathersâ€, Int. J. Renew. Energy Res, Vol. 5, No. 1, pp. 251-257, Mar 2015.

M. Gonen, D. Balkose, F. Inal, and S. Ulku, “The effect of zinc stearate on thermal degradation of paraffin waxâ€, J. Therm. Anal. Calorim, Vol. 94, No. 3, pp. 737-742, Dec 2008.

S. P. Venkateshan, Mechanical Measurements, New Delhi, India: Ane Books, 2008.

M.A. Nazari, M. H. Ahmadi, R. Ghasempour, and M. B. Shafii, “How to improve the thermal performance of pulsating heat pipes: A review on working fluidâ€, Renew. Sustain. Energy Rev, Vol. 91, pp. 630-638, Aug 2018.

R. Naik, V. Varadarajan, G. Pundarika, and K.R. Narasimha, “Experimental investigation and performance evaluation of a closed loop pulsating heat pipeâ€, J. Appl. Fluid Mech, Vol. 6, pp. 267-275, Jan. 2013.

P. Naphon, S. Wiriyasart, and S. Wongwises, “Thermal cooling enhancement techniques for electronic componentsâ€, Int. Commun. Heat Mass Transf, Vol. 61, pp. 140-145, Feb 2015.

M. Zufar, P. Gunnasegaran, H.M. Kumar, and K.C. Ng, “Numerical and experimental investigations of hybrid nanofluids on pulsating heat pipe performanceâ€, Int. J. Heat Mass Transf, Vol. 146, pp. 118887, Jan 2020.

L.N. Narasimhan, “Assessment of latent heat thermal storage systems operating with multiple phase change materialsâ€, J. Energy Storage, Vol. 23, pp. 442-455, Jun 2019.

L. Kalapala, and J.K. Devanuri, “Influence of operational and design parameters on the performance of a PCM based heat exchanger for thermal energy storage–A reviewâ€, J. Energy Storage, Vol. 20, pp. 497-519, Dec 2018.

Y.H. Diao, S. Wang, C.Z. Li, Y.H. Zhao, and T.T. Zhu, “Experimental study on the heat transfer characteristics of a new type flat micro heat pipe heat exchanger with latent heat thermal energy storageâ€, Exp. Heat Transf, Vol. 30, No. 2, pp. 91-111, Mar 2017.




DOI (PDF): https://doi.org/10.20508/ijrer.v10i4.11490.g8062

Refbacks

  • There are currently no refbacks.


Online ISSN: 1309-0127

Publisher: Gazi University

IJRER is cited in SCOPUS, EBSCO, WEB of SCIENCE (Clarivate Analytics);

IJRER has been cited in Emerging Sources Citation Index from 2016 in web of science.

WEB of SCIENCE between 2020-2022; 

h=30,

Average citation per item=5.73

Impact Factor=(1638+1731+1808)/(189+170+221)=9.24

Category Quartile:Q4